Grundig GKN4685VPZ, Руководство пользователя

Страница: 11 / 29

11
C
If two coolers are to be
installed side by side,
there should be at least
4 cm distance between
them.
•
If the product will be placed in
an alcove, remember to leave at
least 5 cm clearance between
the product and the ceiling,
rear wall and the side walls.
Check if the rear wall clearance
protection component is present
at its location (if provided with
the product). If the component
is not available, or if it is lost
or fallen, position the product
so that at least 5 cm clearance
shall be left between the rear
surface of the product and the
wall of the room. The clearance
at the rear is important for
efficient operation of the
product.
3.3 Electrical connection
Connect the product to a grounded
outlet protected by a fuse
complying with the values in the
rating plate. Our company shall
not be liable for any damages that
will arise when the product is used
without grounding in accordance
with the local regulations.
•
Electrical connection
must comply with national
regulations.
•
Power cable plug must be within
easy reach after installation.
•
The voltage and allowed fuse or
breaker protection are specified
in the Rating Plate which is
affixed to interior of the product.
If the current value of the fuse
or breaker in the house does
not comply with the value in the
rating plate, have a qualified
electrician install a suitable
fuse.
•
The specified voltage must be
equal to your mains voltage.
•
Do not make connections via
extension cables or multi-plugs.
B
WARNING:
Damaged
power cable must
be replaced by the
Authorised Service
Agents.
B
WARNING:
If the
product has a failure, it
should not be operated
unless it is repaired by
the Authorised Service
Agent! There is the risk of
electric shock!
Attaching the plastic wedges
Use the plastic wedges in the
provided with the product to provide
sufficient space for air circulation
between the product and the wall.
1.
To attach the wedges, remove
the screws on the product and
use the screws provided with
the wedges.
2.
Attach 2 plastic wedges on the
ventilation cover as shown in
the figure.