Grundig 43 VLE 5523 BN, Инструкция пользователя

Страница: 20 / 82

ENGLISH
20­
INITIAL­SET-UP
­---------------------------------------------------------------------------------------------------
Tuning­terrestrial­channels­­
(DVB-T)
1­
In the »Source Setup« menu, in the »Con-
nection Type« line, select the option »Air«
with »
<
« or »
>
«.
2­ Select the line »Scan Type« with »
V
« or
»
Λ
«.
Use »
<
« or »
>
« to set the required scan
type:
– »DTV«, scan for digital television channels;
– »ATV«, scan for analogue television
channels;
– »ATV & DTV«, scan for analogue and
digital television channels.
Caution:
7
The antenna power supply (5V ) may
only be switched on if the antenna is an
active indoor antenna with a signal
amplifier and it is not already supplied with
a voltage via a mains plug (or similar
supply). Otherwise you may cause a short
circuit and irreparably damage your
antenna.
3­ Select the line »Active Antenna Power« with
»
V
« or »
Λ
«.
Switch on the antenna power supply for the
antenna with »
<
« or »
>
« (»On«).
4­ Start the scan with »

« (green).
– The »Search Results« menu appears, and
the search for channels begins.
– Depending on the number of channels re-
ceived, this can easily take a few minutes.
– The scan is complete as soon as the
»PROGRAM TABLE« appears.
Note:
7
You can abort the scan by pressing
»
MENU
«.
5­ Press » MENU « to end the setting.
Note:
7
Before recording HD channels, please
check signal quality and Strength, see
chapter "Displaying signal information" on
page 72. If the level is displayed in green,
you can record HD channels without any
problems.
Tuning­channels­from­the­cable­
provider­(DVB-C)
1­
In the »Source Setup« menu, in the
»Connection Type« line, select the option
»Cable« with »
<
« or »
>
«.
2­ Select the line »Scan Type« with »
V
« or
»
Λ
«.
Use »
<
« or »
>
« to set the required scan
type:
– »DTV«, scan for digital channels;
– »ATV«, scan for analogue television
channels;
– »ATV & DTV«, scan for analogue and
digital television channels.
3­
Select the line »Cabel Scan Type« with
»
V
« or »
Λ
«. Select the preferred option
(»Quick« or »Full«) with »
<
« or »
>
«.
– The search function »Quick« sets up the
channels according to the information
provided by your cable provider in the
transmission signal.
– If the option »Full« is selected, the entire
frequency range will be scanned. The
search can take a long time with this op-
tion. This option is recommended if your
cable provider does not support the scan
type »Quick«.
Note:
7
You can accelerate the search. To do this,
you need information about the frequency
and network ID. You are usually able to get
this data from your cable operator or find it
in forums on the Internet.
4­ Start the scan with »

« (green).
– The »Search Results« menu appears, and
the search for channels begins.
– Depending on the number of channels re-
ceived, this can easily take a few minutes.
– The scan is complete as soon as the
»PROGRAM TABLE« appears.
Note:
7
You can abort the scan by pressing
»
MENU
«.
5­ Press » MENU « to end the setting.