Grundfos SRP Series, Инструкция по установке и эксплуатации

Страница: 7 / 21

7
English (US)
3.2 Nameplate
Fig. 2 Nameplate
The nameplate is on the motor housing. The details on the
nameplate are required for ordering spare parts.
The additional nameplate supplied with the pump should be fixed
in a visible position at the installation site.
4. Safety
4.1 General safety instructions
5. Transportation, delivery and storage
5.1 Transportation
The individual components of the pump must be packed carefully
to prevent any damage to the surface during transportation.
All lifting equipment must be rated for the purpose and checked
for damage before any attempts to lift the components are made.
The lifting equipment rating must under no circumstances be
exceeded.
5.2 Delivery
On delivery, the pump and any accessories supplied with it
should be checked for transport damage. This also applies when
the equipment is delivered to the installation site.
If the pump or any accessories have been damaged during
transportation, contact your local Grundfos company before
continuing to install the equipment. Do not dismantle a damaged
new component for further inspection, unless instructed by your
local Grundfos representative.
The packaging material must be disposed of according to local
regulations.
5.3 Storage
The pump must be stored in a dry location in which the
temperature is not subject to major fluctuations.
If the pump has been stored for more than one year, the gearbox
oil must be changed. The oil must be changed even if the pump
has never been in use. This is necessary because of natural
aging of mineral oil lubricants.
TM
04
92
49
10
37
Pos. Description
1 Type designation
2 Production code
3 Propeller diameter
4 Liquid temperature range
5 Product number
6 Enclosure class according to IEC
7 Serial number
8 Insulation class
9 Rated voltage
10 Rated speed (propeller)
11 Weight
12 Starting current
13 Frequency
14 Number of poles
15 Rated current
16 Power factor
17 Motor power P
1
/P
2
18 Model
19 Maximum installation depth
20 Service factor
Warning
Before starting work on the product, make sure
that the fuses have been removed or the mains
switch has been switched off. Make sure that the
power supply cannot be accidentally switched
on.
Type
P.c.
P
1
/P
2
Cos.
Model
in
A
Hz
F
ø
I
N
n
N
Pol
T
Prod.No:
96257011
See MANUAL!
CH-6105 Schachen
Insul.class:
No:
IP
U V
I
start
Weight lb
/min A
15 12 14 13
1 2 3 4 5 6 7
18
17
16
19
HP
ft
9
10
11
8
S.F.:
20
Warning
These safety instructions as well as the
instructions in each individual section must be
followed when transporting, storing, handling
and operating the pump.
The pump must be installed, connected, started
up and serviced by qualified persons.
Beware of rotating parts.
Make sure that persons cannot accidentally fall
into the tank, e.g. by installing a cover or railing.
Warning
Make sure that the pump cannot roll or fall over.
Warning
Before attempting to lift or otherwise handle the
individual components of the pump, observe any
local regulations that set limits for the weight of
the components to be lifted manually by
individuals, i.e. handled without the use of lifting
equipment.
Warning
A damaged pump must not be installed.