English (GB)
43
11.10 Requesting settings in the service menu
In the "Service" menu, the most recent messages
(list of events), the measuring data for the sensors,
the data for the auto test and the sensor data can be
displayed for the relevant sensor.
In addition, the current outputs, relays and the
display can be tested, i.e. the proper operation of the
Conex
®
DIA-G and connected warning and safety
equipment can be checked.
Sensor 1/2
In the "Sensor 1" or "Sensor 2" submenu, the
following menu points are available:
•
List of events
•
Measured value
•
Auto test
•
Sensor data
•
Settings.
List of events:
The last 10 events (limit value
exceeded or sensor fault) are stored chronologically
with date and time and can be viewed. The events
are shown in the display as follows:
Event:
•
LV 1 On = Limit value 1 On
•
LV 1 Off = Limit value 1 Off
•
LV 2 On = Limit value 2 On
•
LV 2 Off = Limit value 2 Off
•
Sensor fault.
Main menu > Service
Submenu 1
Submenu 2
Submenu 3
Sensor 1
List of events
Measured value
Aut. test
Sensor data
Settings (S1)
Limit values
Alarm relay
Sensor 2
List of events
Measured value
Aut. test
Sensor data
Settings (S2)
Limit values
Alarm relay
Test current
Current output 1
0/4 mA: on
10/12 mA: off
20 mA: off
Current output 2
0/4 mA: on
10/12 mA: off
20 mA: off
Test relay
Relay 1: off
Relay 2: off
Relay 3: off
Relay 4: off
Alarm: off
Test display
List of events
Number: 1
Event: LV 1 On
Date: dd.mm.yyyy
Time: hh:mm:ss