Grunbeck pureliQ:R, Руководство по эксплуатации

Страница: 24 / 44

Start-up
24 | 44
B
A
_
TD
3
-A
R0
0
0
en
_
0
3
5
5.3 Setting pressure reducer (only pureliQ:RD)
The factory setting for the pressure reducer is 4 bar. You can
change this value as follows:
1. Open the withdrawal point.
2. Set the desired after-pressure on the handwheel for
pressure reducer by turning it.
3. Read off the measured actual after-pressure at the
pressure gauge on the front of the housing.
4. Close the withdrawal point.
+
-