GRS Power Hone B, Эксплуатация и обслуживание, Страница: 1 / 6

POWER
HONE
M O D E L B
The GRS Diamond
Power Hone is designed for a
long, useful service life. The spindle is driven
by a smooth belt system at 240 RPM. The
diamond wheel supplied with your hone provides
true diamond performance. This means carbides,
hard metals, ceramics, and other exotic
materials are all within the capability of your
Power Hone. Replacement diamond wheels are
available from GRS Tools in several grits for a
wide range of applications.
TOOL SHARPENING
When using the Power Hone, hold the
tool relatively stationary while the rotary
motion of the wheel sharpens the tool.
Sweep the tool slowly across the working
surface of the wheel. This extends wheel
life by using the entire cutting face and
prevents grooving. The Power Hone is
designed mainly for fine tool sharpening
and finishing. Use a bench grinder to rough
shape tool points, then give them a fine
finish on the Power Hone. This will save
time and extend diamond wheel life.
Engraving & Jewelry Tools
The Power Hone was originally
designed to sharpen engraving and jewelry
tools. Sharpening fixtures to hold the
gravers to the precision angles required
for fine engraving tools are available
from GRS Tools. See the “accessories”
section or the GRS Tools catalog for the
sharpening fixtures that are available.
NOTE:
For very delicate work such as heeling
small gravers, try using the diamond wheel
with the machine turned off. This will
prevent removing too much material.
Household & Shop Items
The Power Hone is useful around the
house and shop to sharpen items like;
scissors, knives, craft tools, hobby
tools, chisels, wood and metal lathe
tools, etc. With the ceramic lap wheel
you can even put an edge on a
razor blade.
OPERATION AND
MAINTENANCE OF THE
Lit #193
TM
FIRST - Align the pin located on
the spindle with hole in the QC
Drive Plate. Make sure plate
rests fully on spindle. Insert
Spindle Nut, tighten snug
with a 3/8" open end wrench.
(Do NOT over tighten) Plug
machine in, turn it on, check
to see if plate runs true and
does not wobble. If it wobbles,
turn off, double check that
the pin aligns with the hole
in QC plate and is seated
properly on spindle.
Place diamond wheel on
top of QC plate and insert
thumb screw / washer into
spindle nut and finger tighten.
ALIGN
PIN IN
HOLE
3/8"
OPEN
END
WRECH
FINGER
TIGHTEN ONLY
SPINDLE
NUT
QC DRIVE
PLATE
ATTACHING THE
QUICK CHANGE
DRIVE PLATE
SPINDLE
PIN