English en-3
12mm
POWER: 24 VDC / 3.75 A (MAX)
GraverHone VS
0000000000000
A
B
C
D
Overview
FIG . 1
A. Power on/off button
B. Reverse rotation switch position
C. Forward roation switch position
D. Rotations Per Minute (RPM) dial
E. 24-volt power receptacle
F. Spindle
G. Drive plate (#111-522)
H. Metal washer (#024-417)
I. Bolt (#111-515)
J. Quick Lock Knob & Spring
(Wheel Lock) (#111-521)
Attach Drive Plate
FIG . 2
E
F
I
F
G
Front View
Back View
Top View (with Drive Plate)
E
INTRODUCTION
The GraverHone VS is designed to be
used for the purpose of sharpening and
polishing tools.
SETUP
ATTACH DRIVE PLATE & WHEEL (FIG . 2)
Place drive plate (G) on spindle (F). Place metal
washer (H) in inset at center of drive plate.
Thread bolt (I) into center of drive plate and
secure on spindle. Tighten with 12 mm wrench.
Place wheel on drive plate. Align and place
quick lock knob and spring (J) assembly over
bolt. Push down and twist into locking position.
CONNECT ELECTRICAL POWER (FIG . 3)
Insert the converter cord into receptacle on
unit (FIG 3.1). Connect the electrical power
cord into the 24-volt power converter (FIG 3.2).
Connect the 2-prong power cord into a properly
grounded power outlet.
OPERATION
Press power on/off button to power unit on.
(FIG. 1 A).
Unit must not be in operation while
installing or removing sharpening wheel.
If not
installed, attach wheel securely on drive plate
(FIG. 1 G).
Position RPM dial to desired RPM
setting (FIG. 1 D).
Set rotation switch to clockwise (FIG. 1 C) or
counter-clockwise (FIG. 1 B) as desired. When
finished, set rotation switch to center “off”
position.
When finished, press power on/off
button to power unit off. (FIG. 1 A).
I
J
J
G
H
Connect Electrical Power
FIG. 3
G
I
H
#024-411
#022-994
G
2 .1
2 .2
2 .4
2 .3
2 .5
3 .1
3 .2
