INSTRUCTIONS FOR USING
TYRE SEALANT PUMP
TSP
Congratulations on your purchase of this world-class premium constructionTyre Sealant Pump
Features
-
1. Hand operated Tyre Sealant Pump for
pumping tyre sealant into tubeless
tyres
3. Durable Steel construction
4. Sealant Discharge in down stroke
5. Dispenses 230 ml (8 oz. ) per stroke
6. Fits 5 to 6-1/2 gallon drums
Wetted Components:
Steel, Aluminum, NBR & PVC
Piece Count
1.
Pump Assembly
2. Aluminum Die cast handle
3. 12” Drum Cover with Adjusting
Flange & thumb bolts
4. 5' Discharge hose with 3/8” NPT (M) x
¼” NPT (F) end connections
5. Quick Connect Coupler ¼” NPT (F)
6. Return Valve
PUMP
OUTLET
ALUMINUM DIE
CAST HANDLE
PLUNGER ROD
ADJUSTING
FLANGE
PUMP
ASSEMBLY
PISTON
ASSEMBLY
NON RETURN
VALVE
ADJUSTING
COLLAR
DRUM COVER
THUMB
BOLTS
RETURN
VALVE
QUICK
CONNECT
COUPLER
DISCHARGE
HOSE
ASSEMBLY
1. Connect the Aluminum Die cast
handle to the Plunger Rod of the
pump
2. Assemble the thumb bolts onto the
drum cover. Do not tighten fully , just
enough for the bolts to stay connected
with the drum cover
3. Drum cover is fitted with an Adjusting
flange in the center. The flange is bolted to the drum cover & must not be opened. There is another bolt & nut
provided on the flange, which allows the center opening to be adjusted. Loosen this fully.
4. Open the Tyre Sealant container on which the pump is to be installed & place the drum cover on top of the rim
of the container
5. Now insert the pump tube from the center opening on the flange
6. Once the pump tube touches bottom of the container, adjust the drum cover onto the rim of the tyre sealant
container & tighten it using thumb bolts. The die cast flange in the center of the drum should now be tightened.
7. Tighten the Adjusting Collar mounted on pump's plunger rod. This will pre-set the amount of tyre sealant dispensed
per stroke
8. Connect the Discharge Hose to the threaded Pump outlet on the Aluminum Die cast handle. The other end of the
discharge hose should be connected to the Quick Connect Coupler
9. A Return Valve is provided in the pack. This maybe fitted onto the drum cover by punching out the hole depression
on the cover. This may be used to drain back the left over sealant after the pump has been used.
