Installation Guide
360° Multi-Voltage Mini LED Beacon
Model 78113
Please review all of the following requirements prior to installing the this light. Failure to follow these safety precautions and
instructions could result in damage to the product or vehicle and could result in serious injury to you and your passengers.
Improper installation may result in serious injury, property damage, or death. The installer must have a good understanding of automotive electronics,
systems, and procedures.
If you are drilling any holes while mounting this light, please be sure to check both sides of the surface to ensure that you do not damage anything.
De-
burr all holes.
Ensure that any switches used are located in an area that allows the vehicle and device to be operated safely in any driving condition.
Use a minimum 18AWG wire for electrical connections and a 5A fuse at the power source, ensuring both positive and ground connections are
dependable.
Test the light and inspect all wiring each time you use the vehicle to ensure that it is functioning properly. If it is not functioning properly, do not
operate
the vehicle!!
Use only soap and water to clean this product. Use of harsh chemicals could cause the domes to haze and may lead to diminished light output
reducing the effectiveness. Do not use a power washer to clean this product.
Please Note: These instructions are provided as a general guideline only. Specific mounting, wiring, and/or weather-sealing may be necessary and
are the sole responsibility of the installer. The manufacturer assumes no responsibility for the integrity of the installation for this or any of its products.
This light uses high-intensity lights. DO NOT st
are directly into the light while it is on, as momentary blindness
and/or permanent eye damage may occur.
