Gröne 2560-210700, Руководство по эксплуатации, Страница: 43 / 326

43
5. Allow the pump to operate and observe the fluid coming out of the drain pipe. Allow the fluid
to flow until the moment when from the drain pipe clean spray substance starts to come out.
6.
Aim the gun inside the bucket for waste, unlock the trigger and hold it open. Then close the
overflow valve.
7. Stop the trigger in the open position, allowing the pump to work and look at the fluid coming
out of the gun. Allow the fluid to flow until the moment when from the drain pipe clean spray
substance starts to come out. Turn off the device.
8.
In order to thoroughly get rid of any air, aim the gun inside the buckets on the substance to be
sprayed or the hopper and leave the trigger open. Turn on the device and allow the substance
to circulate. Watch the substance to ensure that there are no air bubbles in it.
9. Now switch the device off and lock the trigger.
The drain pipe can be now re-connected with the suction pipe in the bucket with the substance.
You can place the cover and the tip on the device primed in such a way.
ASSEMPLY OF THE COVER AND THE SPRAY TIP (bilateral ends)
WARNING: If pressure is maintained in the device, before any adjustments with the tip on, apply the
DECOMPRESION PROCEDURE.
Please refer to the section below “Select a spray tip” to choose a tip suitable for the intended use.
1.
Before installing the nozzle and the tip cover, make sure that the safety catch is locked twice.
2. If it is not already installed, make sure that the gasket is in place in the socket and insert the
socket into the tip cover. Make sure it is set on the line of the round opening in the tip cover.
3. Place the tip cover of the gun and push only with your fingers.
4. Insert the tip into the tip cover and make sure that it is fully pressed. Turn the tip to the front
position (the arrow on the tip handle will indicate the front position). The tip may be turned by
180 degrees to clean any clogs.
5. Turn the tip cover to the desired orientation and tighten the counter cap with your hand.
WARNING: Never spray if the tip is in any other position than straight forward or straight backward.
Doing so may cause the danger associated with high pressure.
The device is now ready to spray.
TIP
SEALANT
TIP COVER