-4-
Model T32305 (Mfd. Since 08/20)
Controls &
Components
A. Hydraulic Ram: Drives logs into splitting
wedge. Delivers 6 tons of ram force.
B. Log Table: Supports logs during log splitting
operations.
C. ON Button: When pushed and held,
starts and runs motor to pressurize
hydraulic fluid. ON button and hydraulic
control lever must be held simultaneously to
activate hydraulic ram.
To reduce your risk of
serious injury, read this
entire manual BEFORE
using machine.
Refer to the following figures and descriptions to
become familiar with the basic controls and com-
ponents of this machine. Understanding these
items and how they work will help you understand
the rest of the manual and stay safe when operat-
ing this machine.
G. Air Bleed Screw: Loosen screw slowly to
release air inside hydraulic cylinder.
H. Splitting Wedge: Stationary high-carbon
steel wedge that splits logs.
I. Hydraulic Fluid Tank: Holds 3.6 quarts of
ISO 32 or equivalent hydraulic fluid.
J. Hydraulic Fluid Tank Plug w/Dipstick:
Remove to check fluid level and add/change
hydraulic fluid.
D. Circuit Breaker Reset Button: Circuit
breaker trips if motor draws excessive current
and overheats. Push to reset circuit breaker
after allowing machine to cool down.
E. Hydraulic Control Valve Pressure Release:
Slowly loosen hex bolt to release pressure
inside hydraulic control valve if hydraulic ram
does not return to start position.
F. Hydraulic Control Lever: Push down
to activate hydraulic ram. Hydraulic
control lever and ON button must be pushed
and held simultaneously to activate hydraulic
ram.
Figure 1. Controls and components—rear.
F
A
B
E
D
C
Figure 2. Controls and components—front.
G
H
I
J
