Grizzly T32002, Руководство пользователя

Страница: 18 / 36

-18-
Model T32002 (Mfd. Since 02/20)
Assembly
To assemble machine:
1. Attach tool rest to mounting bracket using
M6-1 x 13 knob (see Figure 9). There should
be no more than
1
⁄
8
" between tool rest and
grinding wheel.
The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to
Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
2. Attach safety shield to wheel cover using (2)
M4-.7 x 5 Phillips head screws, as shown in
Figure 10.
Knob
Figure 9. Tool rest attached to mounting
bracket.
Tool Rest
Figure 10. Safety shield attached to wheel
cover.
Safety Shield
x 2
Wheel Cover
Test Run
Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The
Troubleshooting table in the
SERVICE section of this manual can help.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
To test run machine:
1. Clear all setup tools away from machine.
2. Turn variable-speed dial all the way counter-
clockwise.
3. Connect machine to power supply.
4. Verify motor operation by slowly turning
variable-speed dial clockwise to turn machine
ON. Rotate dial back and forth to test variable-
speed function. Motor should run smoothly
and without unusual problems or noises.
5. Turn variable-speed dial all the way
counterclockwise to turn machine
OFF.
Congratulations! Test run is complete.
The Test Run consists of verifying the following: 1)
The motor powers up and runs correctly.
Mounting Bracket