Grizzly H0937, Инструкция по эксплуатации

Страница: 7 / 16

-5
-
H0937 Electric Winch
INSTALLATION
Wiring Your Grizzly Winch
2. Connect the red alligator clip to the
positive (+/RED) terminal of your bat-
tery. Use only a 12V battery source
that is in good working condition.
Connect the black alligator clip to the
frame of your vehicle to establish a
ground connection.
3. Plug the remote control switch into the
second plug socket on the side of the
winch. This remote switch allows the
winch to be operated from a safe dis-
tance.
4. Set the remote control aside in a safe
place until the winch is ready to oper-
ate.
PERMANENT WIRING
The winch can be permanently wired to
your vehicle or trailer in one of two ways.
Example 1:
The included power cable can be used for
a permanent wire set-up; however, the
alligator clips must be be cut from the
power cable. Replace the red alligator clip
with a suitable connector to allow hook up
to the positive 12V power source and
replace the black alligator clip with a 14
A.W.G. ring tongue connector. Connect
the red positive power cord to the positive
12V power source and the black ring
tongue connector to the frame of the vehi-
cle. Connect the power cable plug into the
plug socket on the side of the winch.
Example 2:
New 14 gauge wiring can also be used for
connecting the winch permanently to the
12V DC electrical system. The winch plug
sockets are not used in this configuration;
instead, the power cable is attached
directly to the solenoid within the winch
body. Remove the plastic body from the
winch and locate the two wires on the
back side of the power cable plug socket.
These two wires will terminate at the sol-
Your winch may be permanently or tem-
porarily wired to a power source.
TEMPORARY WIRING
1. Remove the plug socket cover from
the side of the winch body. Plug the
power cable into the corresponding
plug socket on the winch. Route the
power cable from the winch to your
battery, being careful to avoid getting it
tangled with the other wires or causing
a tripping hazard.
Important Wiring Reminders
1. Always connect the positive
(+/RED) cable to the positive
(+/RED) battery post and the neg-
ative (-/BLACK) cable to the vehi-
cle frame.
2. Never run the battery dead while
using the winch.
3. Running your vehicle while oper-
ating the winch will prevent the
battery from running dead; how-
ever, avoid standing in front or
behind the running vehicle.
Serious personal injury could
occur if the gear became
engaged.
4. Never use a battery that is leak-
ing acid or is badly corroded.
5. Always wear ANSI approved
safety glasses when operating
the winch or working near the
12V battery.
6. Always connect the red alligator
clip to the battery FIRST, fol-
lowed by the black alligator clip
to the vehicle frame.
Failure to comply with these and
other warnings could result in seri-
ous personal injury.