Introduction
Push type pneumatic nibbler makes quick work
of sheet steel up to
1
⁄
16
" thick and soft metal up to
5
⁄
64
" thick. Features 3500 strokes per minute at an
average air consumption of 6 CFM.
Inventory
A.
Pneumatic Nibbler ...................................... 1
MODEL G8124
PNEUMATIC NIBBLER
INSTRUCTION SHEET
Figure 1.
Model G8124.
If you need help with your new pneumatic tool,
call our Tech Support at: (570) 546-9663.
COPYRIGHT © APRIL, 2006 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#PC8128 PRINTED IN TAIWAN
INJURY HAZARD!
Always disconnect tool from
air to prevent unexpected
operation during service!
EXPLOSION HAZARD!
Never exceed 90 PSI!
EYE/EAR INJURY HAZARD!
Wear safety glasses and
hearing protection during
use of this tool!
Operation
Connect a
1
⁄
4
" MNPT air fitting to the pneumatic
nibbler and then to your regulated air source.
This pneumatic nibbler MUST have 3-4 drops of
oil directly dropped into the air fitting before each
use.
