Grizzly G0948, Руководство пользователя

Страница: 21 / 68

Model G0948 (Mfd. Since 08/21)
-19-
Adjustment
Overview
The bandsaw is one of the most versatile wood-
working machines. However, it has multiple com-
ponents that must be properly adjusted for the
best cutting results.
For practical and safety reasons, some adjust-
ments and test operations must be performed
before performing other necessary adjustments.
Below is an overview of all the adjustments and
the order in which they should be performed:
1. Initial Blade Tracking
2. Test Run
3. Tensioning Blade
4. Adjusting Blade Support Bearings
5. Adjusting Blade Guide Bearings
6. Aligning Table
7. Aligning Fence
To connect a dust collection hose:
1. Fit 2", 3" or 4" dust hose over dust port, as
shown in Figure 19, and secure it in place
with a hose clamp.
Dust Collection
This machine creates a lot of wood chips/
dust during operation. Breathing airborne
dust on a regular basis can result in perma-
nent respiratory illness. Reduce your risk
by wearing a respirator and capturing the
dust with a dust-collection system.
2. Gently pull hose to make sure it does not
come off. A tight fit is necessary for proper
performance.
2" Dust Port.......................................... 100 CFM
3" Dust Port.......................................... 250 CFM
4" Dust Port.......................................... 400 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
Figure 19. Example of 2" dust hose attached to
dust port.
Dust
Hose
Hose
Clamp