Grizzly G0894, Руководство пользователя

Страница: 18 / 48

-16-
Model G0894 (Mfd. Since 05/19)
Inventory
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Box 1 (Figure 8) Qty
A. CNC Router (Not Shown) ........................... 1
B. Collet ER20
1
⁄
8
" ........................................... 1
C. Collet ER20
1
⁄
4
" ........................................... 1
D. Collet ER20
1
⁄
2
" ........................................... 1
E. Spindle Nut ................................................. 1
F. Power Cord ................................................. 1
G. Open-End Wrench 27/30mm ...................... 1
H. Open-End Wrench 18/21mm ...................... 1
I. Hex Bolt M8-1.25 x 40 ................................ 4
J. Hold-Down Clamp ...................................... 4
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Figure 8. G0894 inventory.
F
G
H
L
I
J
K
M
R
B C D
S
T
E N
O
P
Q
K. Flat Washer 8mm ....................................... 4
L. Wing Nut M8-1.25 ....................................... 4
M. T-Slot Bolt M8-1.25 x 80 ............................. 4
N. Dust Shoe ................................................... 1
O. Dust Shoe Mount ....................................... 1
P. Phlp Hd Scr M5-.8 x 40 .............................. 1
Q. Nut M5-.8 .................................................... 1
R. USB Cable .................................................. 1
S. 50-Pin Cable .............................................. 1
T. Hand-Held Controller ................................. 1
U. Spindle Cooling Pump (Not Shown) ........... 1