Grizzly G0866, Руководство пользователя, Страница: 37 / 100

Model G0866 (Mfd. Since 11/18)
-35-
Required Sanding Belt Size ..............37" x 75"
Included 37" x 75" Sanding Belts Qty
100-Grit ............................................................. 1
180-Grit ............................................................. 1
The Model G0866 only accepts 37" wide by
75" long sanding belts. For additional sanding
belt selections beyond those included with the
machine, refer to
Accessories on Page 39.
We recommend using aluminum-oxide sand-
ing belts for best results. The grit you choose
will depend on the condition and species of wood,
and the level of finish you wish to achieve.
When choosing sanding belts, use these grit
numbers as a general guide:
Grit Type
60 or less ..................................................Coarse
80-100 ................................................... Medium
120-150 ......................................................... Fine
180+ ............................................................Finish
The general rule of thumb is to sand a workpiece
with progressively higher grit numbers—in incre-
ments of 50 or less.
Note: Sandpaper finer than 180-grit will easily
load up or burn workpieces.
Installing/Changing
Sanding Belts
To install sanding belts:
1. Start air compressor.
2. DISCONNECT MACHINE FROM POWER!
3. Open upper left access door.
Figure 51. Sanding belt tension knob positions.
Tension Position
Detensioned
Position
5. Remove lock post release lever (see Figure
52) by turning it counterclockwise a
1
⁄
2
turn
and pulling it up and out of mounting hole.
6. Remove spacer block (see Figure 52).
4. Turn belt tension knob to detensioned posi-
tion (see Figure 51).
Directional arrows on back of sanding belt
must be pointing in a counterclockwise
direction during installation. Failure to
install sanding belt correctly will result in
damage to sanding belt.
Figure 52. Components used when installing a
sanding belt.
Lock Post
Release
Lever
Belt Tension
Knob
(Detensioned)
Spacer Block