Model G0866 (Mfd. Since 11/18)
-33-
Use the following tables to determine the
approximate maximum depth-of-cut (DOC)
for relative conveyor feed rates. After selecting
the appropriate feed rate chart, find the grit size
you plan to use. Locate the correct DOC for that
grit by selecting the correct wood hardness of the
workpiece, and note the maximum DOC for the
platen setting (up, even, or down).
Approximate Max Depth-of-Cut (DOC) for 15"
Stock
Grit Size Hard
Soft Max DOC Position
60
0.030" 0.040"
n/a
Up 1.5mm
80
0.025" 0.035"
n/a
Up 1.5mm
100
0.020" 0.030"
0.010"
Even
120
*0.015" *0.020" 0.010"
Even
150
*0.010" *0.015" 0.007"
Even
180
0.005" *0.010" 0.005" Down 0.5mm
240
*0.003" *0.005" 0.002"
Down 1mm
Wood Hardness
Platen Settings
16 FPM
23 FPM
Grit Size Hard
Soft Max DOC Position
60
0.025" 0.035"
n/a
Up 1.5mm
80
0.020" 0.030"
n/a
Up 1.5mm
100
0.015" 0.020"
0.007"
Even
120
*0.010" *0.015" 0.007"
Even
150
0.005" *0.010" 0.005"
Even
180
*0.003" *0.005" 0.002" Down 0.5mm
240
*0.002" *0.004" 0.001"
Down 1mm
Wood Hardness
Platen Settings
33 FPM
Grit Size Hard
Soft Max DOC Position
60
0.020" 0.030"
n/a
Up 1.5mm
80
0.015" 0.025"
n/a
Up 1.5mm
100
0.010" 0.015"
0.005"
Even
120
*0.007" *0.010" 0.005"
Even
150
*0.005" *0.007" 0.003"
Even
180
*0.003" *0.005" 0.002" Down 0.5mm
240
0.001" *0.003" 0.001"
Down 1mm
Wood Hardness
Platen Settings
*These numbers assume the platen is raised up
during the sanding pass.
Figure 49. Location of amp load meters.
Amp Load
Meters
IMPORTANT: As you sand, observe the amp
load meter (see
Figure 49). If the amp load meter
indicates motor overload, lower the table slightly
or reduce the feed rate.
Figure 48. Platen height components.
Platen Height
Gauge
Platen Adjustment
Dial
Note: These numbers are approximate values
only. They are provided with the intent of giving
you a "ballpark" idea of what to expect for material
removal rates from this machine. Many additional
factors can influence the maximum depth-of-cut
or removal rates that can be achieved with each
pass (i.e. oscillation speed settings, depth-of-
cut taken on previous pass, actual hardness of
workpiece, etc.), so do not be surprised if you
experience slightly different results.
Содержание G0866
Страница 73: ...Model G0866 Mfd Since 11 18 71 READ ELECTRICAL SAFETY ON PAGE 68 Electrical System Wiring Schematic...
Страница 100: ......