Grizzly G0866, Руководство пользователя, Страница: 31 / 100

Model G0866 (Mfd. Since 11/18)
-29-
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
To test run machine:
1. Clear all setup tools away from machine.
2. Press Emergency Stop button on control
panel (see Figure 44).
3. Turn air compressor ON and verify pressure
gauge on air regulator is set to approximately
75 PSI.
4. Connect machine to power. Power indicator
should illuminate (see Figure 44).
5. Twist Emergency Stop button clockwise until
it springs out. This resets the switch so the
machine can start.
6. Verify power supply is connected to machine
with correct polarity by pressing Table Up
(
) and Table Down ( ) keys, respec-
tively (see
Figure 45).
Test Run
Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The
Troubleshooting table in the
SERVICE section of this manual can help.
The test run consists of verifying the following: 1)
the sanding belts tension when the tension switch
is turned
ON, 2) the power supply polarity is cor-
rect, 3) the motors power up and run correctly, 4)
the Emergency Stop button works correctly, and
5) the EMERGENCY STOP! plate works correctly.
3. Close and latch access and electrical box
doors and reconnect machine to power.
4. Follow Test Run to ensure that machine
functions properly.
Figure 45. Table controls.
Table Down
Key
Table Up
Key
Figure 44. Emergency Stop button and power
indicator.
Emergency Stop
Button
Power
Indicator