Grizzly G0866, Руководство пользователя, Страница: 62 / 100

-60-
Model G0866 (Mfd. Since 11/18)
To change table elevation V-belt:
1. DISCONNECT MACHINE FROM POWER!
2. Open lower left access panel.
Table Elevation
Motor
V-Belt
Jam Nut
Adjustment
Nut
Figure 105. Table elevation motor V-belt tension
components.
Tools Needed Qty
Open-End Wrench 12mm .................................. 1
Changing Table Elevation V-Belt
Changing V-Belts
Check the V-belts periodically for signs of glaz-
ing, cracking, fraying, oil/grease on belts, or any
other evidence of damage or wear. If any of these
conditions are present, replace the V-belt. If either
of the main motor V-belts show these conditions,
replace both of the V-belts as a matched set.
5. Rotate V-belt tension adjustment nuts to
raise or lower motors until there is approxi-
mately
1
⁄
2
"–
3
⁄
4
" deflection when V-belts are
pushed with moderate pressure, then tighten
jam nut to secure.
— Rotate adjustment nuts clockwise to
allow motors to drop and apply tension to
V-belts.
— Rotate adjustment nuts counterclockwise
to raise motors and release V-belt tension.
6. Close and secure access panels.
3. Loosen V-belt tension jam nut to allow motor
to raise or lower (see Figure 105).
4. Rotate V-belt tension adjustment nut coun-
terclockwise to release V-belt tension (see
Figure 105) until you can remove V-belt from
pulleys
5. Place new V-belt onto table pulley and then
loop other end of V-belt around motor pulley
(see
Figure 106).
Figure 106. Location of table and motor pulleys.
Table Pulley
Motor Pulley