Grizzly G0866, Руководство пользователя, Страница: 44 / 100

-42-
Model G0866 (Mfd. Since 11/18)
Grease Fittings
Oil Type ............... T26419 or NLGI#2 Equivalent
Oil Amount ............1–2 Pumps from Grease Gun
Frequency ................................................ Weekly
Figure 65. Location of conveyor belt roller axle
grease fitting.
Figure 67. Location of table elevation
leadscrews, chain, and sprockets.
Chain
Motor Belt
(1 of 2)
Sprocket
(1 of 4)
Leadscrew
(1 of 4)
Table Elevation Leadscrews, Chain &
Sprockets
Oil Type ............... T26419 or NLGI#2 Equivalent
Oil Amount ............................................Thin Coat
Frequency ................................................Monthly
Figure 66. Locations of upper left/right sanding
belt roller axle grease fittings.
Items Needed Qty
Rag ................................................................... 1
Grease Gun ....................................................... 1
Wipe the fittings clean with a rag. Attach a flexible
grease gun extension to a grease gun. Add one or
two pumps of grease to the grease fitting located
on the conveyor belt roller axles and the sanding
belt roller axles (see
Figures 65–66). They are
identified with yellow labels.
Items Needed Qty
Rag ................................................................... 1
Mineral Spirits .................................... As Needed
Wire Brush ......................................................... 1
Lower table all the way, then open lower right
and left access doors. Use shop rag and min-
eral spirits to remove old lubricant and built-up
grime from leadscrews, chain, and sprockets (see
Figure 67). Brush grease onto leadscrews, chain,
and sprockets, being careful to not get grease
on V-belts. This could cause V-belts to slip on
pulleys. If you do get grease on V-belts, replace
them. Raise table up and down a few times to
evenly distribute grease.