Grizzly G0726, Руководство пользователя, Страница: 48 / 80

-46-
Model G0726 (Mfg. Since 7/11)
Quill Gearing
Oil Type .....Grizzly T23962 or ISO 68 Equivalent
Amount .............................................. Fill Oil Cup
Add Frequency ..................4–8 hrs. of Operation
Lift the oil cup cap shown in
Figure 62 to add the
oil.
Bull Gear
Grease Type ...................... NLGI#2 or Equivalent
Amount .................Two Pumps from Grease Gun
Add Frequency .................... 40 hrs. of Operation
Use a grease gun to add lubricant to the grease
fitting shown in
Figure 64.
Figure 62. Quill gearing oil cup.
Oil
Cup
One-Shot Oiler
Oil Type .....Grizzly T23962 or ISO 68 Equivalent
Amount ....................... One Pull of Pump Handle
Check/Add Frequency .......4–8 hrs. of Operation
Reservoir Capacity ......... Approximately
1
⁄
2
Quart
The one-shot oiler is connected to a series of
tubes that carry the lubricant to wear points
along the table, saddle, knee ways, and the lead-
screws. After using the oiler pump handle shown
in
Figure 63, move the table through all paths of
movement to evenly distribute the lubricant.
Use the sight glass on the front of the oiler to
know when to re-fill the reservoir.
Figure 63. One-shot oiler.
Ram Ways
Oil Type .....Grizzly T23962 or ISO 68 Equivalent
Amount .................................................Thin Coat
Add Frequency .................... 40 hrs. of Operation
Use a shop rag and mineral spirits to wipe
away grime and debris from the ram ways (see
Figure 65). Move the ram back and forth to wipe
a thin coat of oil onto the full length of the ways.
Figure 65. Ram ways.
Ram Ways
Pump
Handle
Figure 64. Bull gear grease fitting.
Grease
Fitting