Grizzly G0622, Руководство пользователя

Страница: 25 / 48

Model G0622 (Mfg 2/08+)
-23-
4. tighten the hex bolts.
5. loosen the hex bolt on the opposite jaw so
the jaw can float, then match the angle of the
workpiece and re-tighten the hex bolt.
6. tighten the vise against the workpiece.
Note: Figure 29 shows the correct methods
of holding different workpiece shapes.
figure 29. Workholding options by material
shape.
3. Use the scale as a guide to set your angle or
use a machinist square to set the angle of the
vise, as shown in
figure 28.
the vise can hold material up to six inches wide
and be set to cut angles from 0° to 60°.
Tools Needed Qty
Wrench or Socket 12mm ................................... 1
Machinist Square ............................................... 1
To use the vise:
1. diSConneCt BAndSAW FroM poWer!
2. loosen the two hex bolts shown in figure 27.
vise
Always turn the saw OFF and allow the blade
to come to a complete stop before using the
vise! failure to follow this caution may lead
to injury.
figure 27. Setting vise angle.
hex Bolts
figure 28. Squaring vise to blade.
Scale