Grizzly G0622, Руководство пользователя

Страница: 18 / 48

-16-
Model G0622 (Mfg 2/08+)
11. place the pulley cover over the motor and
gear shafts, and secure it with the pre-
installed M6-1 x 12 phillips head screws and
12mm flat washers, as shown in
figure 11.
7. With the help of an assistant, lift the bandsaw
onto a pair of closely spaced sawhorses or
other suitable support (see
figure 9).
figure 10. tool tray.
figure 9. leg assembly.
8. Attach the legs to the bandsaw with the
M8-1.25 x 25 hex bolts, 8mm flat washers,
and M8-1.25 hex nuts.
Note: At this time, tighten with a 14mm
wrench or socket just enough to secure the
parts. Final tightening will take place when
the stand is fully assembled.
9. remove the machine from the sawhorses,
then install the tool tray in the middle of
the stand
with the M6-1 x 12 phillips head
screws, 6mm flat washers and M6-1 hex
nuts, as shown in
figure 10.
10. Check to see if the bandsaw is relatively
level, then final tighten all the nuts.
figure 11. installing pulley cover.
12. open the pulley cover, then insert the keys
into the slots on the pulley shafts.
13. Slide the large diameter motor pulley onto the
motor shaft (see
figure 12).
14. install the worm gear pulley with the small
diameter wheel on the shaft closest to the
gear box.
figure 12. installing motor pulley.
Motor pulley
with Key Slot