Grizzly G0510ZW, Руководство пользователя

Страница: 41 / 56

Model G0510ZW (Mfd. Since 9/16)
-39-
Replacing V-Belt
1. DISCONNECT MACHINE FROM POWER!
2. Use wrench to remove motor and spindle
pulley guard (see Figures 53 & 54).
3. Loosen motor mount bolts, shown in Figure
53, ONLY one full-turn.
Router Table
Conversion
To use router bits with shaper, you must convert
the shaper to a router table by installing the pro-
vided table spacers and router bit collet. This
process typically takes approximately 20 minutes.
Tools Needed: Qty
Spindle Wrench 26mm ...................................... 1
Open-End Wrench 14mm .................................. 1
Wrench/Socket 19mm ....................................... 1
Open-End Wrench 8mm.................................... 1
Open-End Wrench 13mm .................................. 1
To convert shaper for use as a router table:
1. DISCONNECT MACHINE FROM POWER!
2. Remove cutter guards, as well as spindle lock
nut and any cutters or rub collars installed on
spindle (see
Figure 55).
Figure 55. Removing spindle lock nut and cutter.
Spindle
Lock Nut
Cutter
3. Remove table from shaper by unscrewing
bolts that secure it in place.
Figure 53. Location of motor mount bolts.
Motor Mount
Bolts
(1 of 2)
Motor
Pulley
Guard
Figure 54. Spindle pulley guard bolts.
Spindle
Pulley
Guard
4. Lift motor and slide motor forward (toward
front of machine) to decrease tension on belt,
then lightly tighten one motor mount bolt to
keep motor from shifting.
5. Remove belt from pulleys and replace with
new belt.
6. Un-tighten motor bolt tightened in Step 4,
and refer to
V-Belt Tension on Page 38 for
proper alignment and tensioning.
7. Once belt is aligned, replace motor and
spindle pulley guards.