Grizzly G0510ZW, Руководство пользователя

Страница: 15 / 56

Model G0510ZW (Mfd. Since 9/16)
-13-
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Inventory
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Box 1 (Figures 5–7) Qty
A. Safety Guard Mounting Post ...................... 1
B. Shaper Assembly ....................................... 1
C. Fence Assembly ......................................... 1
D. Miter Gauge ................................................ 1
E. Stand Sides ................................................ 2
F. Fence Faces ............................................... 2
G. Cross Braces .............................................. 2
H. Table Insert 1
3 ⁄
4
" ......................................... 1
I. Spindle Wrench 26mm ............................... 1
J. Safety Guard Attachment Bar .................... 1
K. Starting Pins ............................................... 2
L. Safety Guard .............................................. 1
M. Rubber Feet ............................................... 4
N. Shaper Bit Collet
1 ⁄
2
" ................................... 1
O. Router Bit Collet
1
⁄
4
" .................................... 1
P. Collet Nut .................................................... 1
Q. Start Knobs M8-1.25 .................................. 2
Router Table Conversion Kit Qty
R. Hex Bolts M12-1.75 x 40 ............................. 5
S. Spacers
1
⁄
2
" ................................................. 7
Hardware (See Chart on Page 1) Qty
• Carriage Bolts M8-1.25 x 10 (Stand) ........ 16
• Flat Washers 8mm (Stand) ...................... 16
• Hex Nuts M8-1.25 (Stand) ........................ 16
• Fender Washers 8mm (Fence) ................. 2
• Hex Bolts M8-1.25 x 12 (Fence) ................. 2
• Phillips Screws M8-1.25 x 20 (Fence) ........ 4
• Flat Washers 8mm (Fence) ........................ 6
• Phillips Screws M4-.7 x 10 (Fence) ............ 2
• Hex Nuts M4-.7 (Fence) ............................. 2
B
C
D
E
F
Figure 5. Shaper inventory components.
G
A
Figure 6. Shaper inventory components.
H
I
J K
L
M
N
O
P
Figure 7. Router table kit components.
R
S
Q