English
23
Jasper
can operate without DMX signal (in AUTOMATIC mode) and can be set so that a single MASTER unit will
command a series of SLAVE units. This function is particularly useful when more units are desired to execute the
same programme in synchrony.
The following picture shows an example of a Master-Slave layout.
6.1 MASTER configuration
The projector can perform a pre-set colour-changer programme.
In order to perform such pre-set programme please refer to the chart below:
The projector will perform a flash if you select a time of 5 seconds, 2 flashes for 10 seconds, 3 flashes for 20 sec-
onds and 4 flashes for 40 seconds.
6.0 Master-Slave and Automatic function (RGBW and DW)
MASTER
SLAVE 1
SLAVE N
IN
OUT
IN
OUT
SLAVE 2
IN
OUT
Terminal resistor
(R=120
ƺ
not included!)
Funzione
Tasti
Descrizione
Master Con-
figuration
AV
the input or the removing of the automatic mode can be performed only after
the log in. The programme is: green-cyan-blue-magenta-red-yellow-white. The
pre-set time of each scene is 5 seconds. If the projector is turned off when it is set
in automatic mode, it will switch on again in automatic mode with the same se-
lected scene time.
Increase of
the scene
duration
P+
Available only if the projector is set in automatic mode. Increase of the scene
time: 5 – 10 – 20 – 40 seconds.
Decrease
of the
scene du-
ration
P-
Available only if the projector is set in automatic mode. Decrease of the scene
time: 40 – 20 – 10 – 5 seconds.
Warning!
If MASTER-SLAVE mode is being used, no other DMX control device must be present along the line!!
