1.1 Safety information
1.1.1 Protecting against electric shock
• Disconnect the unit from mains supply before servicing it or performing any other action.
• Always ground/earth the unit electrically.
• Before connecting the unit to power supplies, verify that operating voltage and frequency are compatible.
• Do not handle the unit with wet hands or in the presence of water.
• Check regularly that the power supply cable is not damaged or crushed.
• Apply to a qualified technician for any regular maintenance action not described in this manual.
1.1.2 Installation
• Fix the unit with screws, hooks or any other support able to bear the weight of the unit itself.
• If the unit is fixed onto a suspended structure, this structure is supposed to bear at least ten times the weight of
all devices to be fixed. Use a secondary fixing tool, as prescribed by in force rules.
• The unit installation actions must be performed by a qualified staff.
1.1.3 Protection against burns and fire
•
Do not install the device on flammable surface. Minimum distance from them should be 0.5 m.
• Do not throw the light output onto a flammable surface, from a distance lower than 35m.
Turn immediately off the unit if light output pointing is not respecting the minimum safety distance.
• The unit is not to be installed in places where the ambient temperature exceeds 35° (95°F).
• The external temperature of the unit surface (front glass) can reach 200°C (392°F).
• The lamp is very hot during operations! Wait at least for 30 minutes before changing.
1.1.4 Protection against lamp explosion
• Please replace any lamp that may present any damage or deformation.
• During the lamp replacement always use adequate body and eye protection (see the lamp manufacturer
instruction)
1.1.5 Weather protection
The unit is classified as device with an IP44 weather protection rate.
1.1.6 Forced ventilation
You will note several air vents on the body of the projector. To avoid any problems associated with overheating,
never obstruct any of these vents as this may seriously compromise the proper operation of the unit.
1.1.7 Protection against UV radiation
• Never operate the fixture with missing or damaged lenses and / or cover.
•
Replace any damaged shields with original GRIVEN spare parts..
• Do not stare directly into the light. Never look at an exposed lamp while it is lit.
Warning!
This unit is suitable for professional use only, not for domestic use.
1.0 Introduction
22
English
Содержание GR0399
Страница 1: ...KOLORJET 4000 GR0402 GR0399 Manuale di istruzioni Instructions manual...
Страница 21: ...NOTE Italiano 21...
Страница 39: ...NOTE English 39...