In this chapter brief essential instructions for an immediate use of the unit are listed. These instructions are neces-
sary to connect and power up the unit, but they will not describe in complete details the functions of the unit it-
self. All other chapters in this manual are therefore supposed to be read, in order to learn all pieces of necessary
information relevant to the unit.
1.
Open the box and check the content as described in the chapter
5.0 Packaging and transport.
2.
Install the unit
as described in the chapter
6.0 Installation.
3
. Untighten the 4 screws
“A”
.
4.
Insert the cables through the cable-glands and perform the
connections, by following the instructions reported in the labels
inside the box.
B:
DMX signal connection
C:
projectors connection
D:
main cable connection
5.
Adjust the DMX address and the operating mode by using the
dip-switch set
“E”
in the side panel of the unit.
6.
Power up the unit.
7.
Close the unit again by tighten the screw
“A”
previously re-
moved.
4.0 Quick turn on
A
D
C
B
E
18
English
