Thank you for selecting this quality
G
riot
'
s
product. The
3-I
n
-1 B
attery
C
harger
/M
aIntaIner
/t
ester
will work with 12 volt
Lead Acid, VRLA, AGM, or Gel type batteries designed for automotive type uses.
The
3-I
n
-1 B
attery
C
harger
/M
aIntaIner
/
t
ester
is a microprocessor controlled unit.
It is possible to plug a battery in, charge it, maintain it, and actually rejuvenate it!
That way the next time the battery is used, it is in better shape than before it was plugged in. This will extend the life of your
battery and keep it 100% charged and ready to go. Enjoy the best!
USEFUL INSTRUCTIONS
CONNECTING TO YOUR VEHICLE
There are three different ways to connect the
3-I
n
-1 B
attery
C
harger
/M
aIntaIner
/t
ester
to your vehicle.
1.
a
llIgator
C
lIp
- The Alligator Clip-On Cable connects directly to the battery post. Make sure that battery terminals are
clean, that the clip-on connectors are making good contact, and that they are firmly attached to the battery posts. This
is the most common way of connecting the
3-I
n
-1 B
attery
C
harger
/M
aIntaIner
/t
ester
to a battery for temporary
use.
Before connecting make sure that the
3-I
n
-1 B
attery
C
harger
/M
aIntaIner
/t
ester
is plugged in and the Power
LED is on. As you connect to the terminals watch the Battery and Fault LEDs on the charger/maintainer. If connected
properly to a battery that is chargeable, the Battery LED will come on and the Fault LED will not.
2 .
B
attery
r
Ing
t
erMInal
- The Battery Terminal Cable connects directly to the battery using the existing nut and bolt
that hold the terminal to the battery post. This is a permanent connection and should be done with care.
When work-
ing with the battery always remove the ground terminal from the battery post first. Leave the negative terminal dis-
connected as you work with the positive terminal.
Remove the positive terminal from the battery post and attach the
positive ring terminal to the positive terminal.
After the ring terminal has been installed on the positive terminal, you
can then connect the positive terminal to the positive post on the battery.
Next attach the negative ring terminal to the
3-i
n
-1 B
attery
C
harGer
/M
aintainer
/t
ester
p
ower
B
attery
s
tatus
F
ault
l
oad
t
ester
o
n
lCd d
Isplay
o
n
lCd d
Isplay
s
Creen
lCd d
Isplay
s
wItCh
l
oad
t
ester
s
wItCh
l
ow
V
oltage
a
larM
s
wItCh
l
ow
V
oltage
a
larM
o
n
