16
MAINTENANCE AND CARE
USING YOUR OPERATOR
1. Your operator can be activated by any of the following devices:
• Operator control panel: Up and Down Buttons
• The Outside Keyswitch or Keyless Entry System (if you have
installed either of these accessories).
• The Remote Control Transmitter. Hold the push button down until
the door starts to move.
2. Opening the Door Manually: DOOR SHOULD BE FULLY CLOSED IF POSSIBLE. Weak or broken springs could allow an open door to
fall rapidly. Property damage or serious personal injury could result.
The door can be opened manually by pulling the release handle down. To reconnect the door, pull the manual release rope towards
the motor until it springs back to its original horizontal position.
Do not use the manual release handle to pull the door open or closed.
3a. When TTC is not set.
When the Operator is Activated by Remote Control:
1.
If open, the door will close. If closed, the door will open.
2.
If closing, the door will stop.
3.
If opening, the door will stop.
4.
If the door has been stopped in a partially open or closed
position, it will reverse direction.
5.
If an obstruction is encountered while closing, the door will
reverse to the OPEN limit position.
6.
If an obstruction is encountered while opening, the door will
stop and reverse for a short distance.
7.
The Safety Beam uses an invisible beam which, when
broken by an obstruction, causes a closing door to open
and prevents an open door from closing.
4. The operator lights will turn on under the following conditions: when the operator is initially plugged in; when power is restored after
interruption or when the operator is activated. Lights will turn off automatically after 2-1/2 minutes.
CARE OF YOUR OPERATOR
Once a Month
•
Disconnect power cord when performing service or maintenance.
•
Manually operate door. If it is unbalanced or binding, call a qualified door technician.
•
Check to be sure door opens & closes fully. Adjust limits and/or force if necessary.
Once a Year
•
Disconnect power cord when performing service or maintenance.
•
Internally the operator does not require additional lubrication.
•
Lightly grease the chain and inside the rail assembly where the trolley slides. Be careful to use gloves around any sharp
metal edge or the rail.
3b. When TTC is set.
When the Operator is Activated by Remote Control:
1.
If open, the door will not move, but the timer will reset
2.
If closing, the door will stop and open.
3.
If opening, the door will continue towards the open limit.
4.
If the door has been stopped in a partially open or closed
position, it will open.
5.
If an obstruction is encountered while closing, the door
will open.
6.
If an obstruction is encountered while opening, the door
will stop and reverse for a short distance.
7.
The Safety Beam uses an invisible beam which, when
broken by an obstruction, causes a closing door to open
and prevents an open door from closing.
Before opening the door manually, ensure
door is at its CLOSED limit position if possible.
WARNING
