GRIDIRON
TM
Custom Tool Storage
TM
Trimmer Line Spool Holder
Installation Instructions
Thank you for purchasing this Gridiron product
1 Fastening hardware is assembled at the factory but can loosen
during shipping. Assemble any loose bolts, washers, and T-nuts
as shown below (NOTE- INCORRECT ASSEMBLY WILL
RESULT IN DAMAGE.)
2 The line holder can be mounted to a post or to an enclosed trailer
wall.
3 Slide the line holder bracket down the post from the top and
tighten the bolts when you have the line holder in position.
4 To mount to an enclosed trailer wall, remove the machine bolts
and t-nuts and use the enclosed sheet metal screws to mount the
line holder to the wall.
5 Open the lid and slide your spool of line onto the spindle inside.
Feed the line through one of the slots in the rubber insert in the
lid. Close the lid and dispense line by pulling out through the lid.
6 To cut line, bend line into small loop and push into the cutter. (see
image)
Assemble all T-nuts with
pilot to inside of post.
WARNING!
DAMAGE MAY RESULT
T-nut
Pilot
