• Away from agents which can cause corrosion,
such as garden chemicals and de-icing salts.
12
TROUBLESHOOTING
Problem
Possible cause Solution
The machine
does not start
The poles are
not assembled
correctly.
Assemble the
poles according
to the instruc-
tions.
The lock-out
button and trig-
ger are not de-
pressed at the
same time.
1. Push and
hold the
lock-out but-
ton
2. While you
hold the
lock-out but-
ton, pull the
trigger.
3. Release the
lock-out but-
ton to start
the machine.
The bar and
chain gets hot
and smokes.
Oil tank is emp-
ty.
Fill the oil tank.
The discharge
port is blocked.
Refer to the
manual to re-
move the bar
and clean out
the debris.
Inlet opening of
inner oil tank is
blocked.
1. Clean the oil
tank.
2. Fill with
clean bar
and chain lu-
bricant.
The sprocket is
stuck and clog-
ged with debris.
1. Clean the
sprocket.
2. Fill with
clean bar
and chain lu-
bricant.
The bar and
chain gets too
hot and can not
cut.
The chain ten-
sion is too tight
or too loose.
Refer to Adjust
the Chain Ten-
sion in the man-
ual.
The chain is dull Sharpen or re-
place the chain.
The chain is put
on backwards.
Refer to Re-
place the Bar
and Chain in this
manual.
Problem
Possible cause Solution
The motor runs,
but the chain
does not cut cor-
rectly, or the
motor stops af-
ter around 3
seconds.
When you use
the machine un-
der load, it
stops.
1. Release the
trigger.
2. Start the ma-
chine again.
The chain is not
lubricated.
Lubricate the
chain to de-
crease the fric-
tion.
13
TECHNICAL DATA
Voltage
48V DC
Guide bar length
203 mm
Chain pitch
3/8" LP (9.5 mm)
Chain gauge
.050" (1.27 mm)
Chain oil capacity
80 ml
Weight (without battery
pack)
4.2 kg
Chain
91PJ033X/CL15033X
Guide bar
080NDEA318/
M1500833-1318TL
14
LIMITED WARRANTY
TOOL WARRANTY
YEAR/ANS/AÑOS
GARANTIE DE
L’OUTIL
HERRAMIENTA
Greenworks hereby warranties this product, to the
original purchaser with proof of purchase, for a period of
four (4) years against defects in materials, parts or
workmanship. Greenworks, at its own discretion will
repair or replace any and all parts found to be defective,
through normal use, free of charge to the customer.
This warranty is valid only for units which have been
used for personal use that have not been hired or
rented for industrial/commercial use, and that have
been maintained in accordance with the instructions in
the owners’ manual supplied with the product from new.
ITEMS NOT COVERED BY WARRANTY:
1. Any part that has become inoperative due to
misuse, commercial use, abuse, neglect, accident,
improper maintenance, or alteration; or
2. The unit, if it has not been operated and/or
maintained in accordance with the owner's manual;
or
3. Normal wear, except as noted below;
8
English
EN
