GreenWorks G40LT30, Руководство оператора

Страница: 7 / 192

5.4 REPLACE THE CUTTING LINE
Figure 15 - 18.
NOTE
Remove the remaining cutting line on the spool.
NOTE
Use only with the nylon cutting line of 1.65 mm diameter.
1. Cut two pieces of cutting line approximately 3m long of
each.
2. Bend one end of the line 1/4 of an inch (6.35mm) .
3. Put the lines into the anchor holes of the spool.
4. Wind the cutting lines around the spool tightly in the
indicated direction.
5. Put the cutting lines in the guide slots.
6. Do not wind the cutting line beyond the edge of the spool.
6 TRANSPORTATION AND
STORAGE
6.1 MOVE THE MACHINE
When you move the machine, you must:
• Wear gloves.
• Stop the machine.
• Remove the battery pack and charge it.
• Assemble the blade guard.
6.2 STORE THE MACHINE
• Remove the battery pack from the machine.
• Make sure that children cannot come near the machine.
• Keep the machine away from corrosive agents such as
garden chemicals and de-icing salts.
• Secure the machine during transportion to prevent
damage or injury. Clean and examine the machine for any
damage.
7 TROUBLESHOOTING
Problem Possible Cause Solution
The ma-
chine does
not start
when you
push the
trigger. No electrical con-
tact between the
machine and the
battery pack. 1. Remove battery pack.
2. Check contact and in-
stall the battery pack
again.
The battery pack is
depleted. Charge the battery pack.
The lock-out but-
ton and trigger are
not pushed at the
same time. 1. Pull the lock-out but-
ton and hold it.
2. Pull the trigger to start
the machine.
The ma-
chine stops
when you
cut. The guard is not
attached to the ma-
chine. Remove the battery pack
and attach the guard to
the machine.
Heavy cutting line
is used. Use only with the nylon
cutting line of 1.65 mm
diameter.
The grass winds
around the motor
shaft or the trim-
mer head. 1. Stop the machine.
2. Remove the battery
pack.
3. Remove the grass from
the motor shaft and trim-
mer head.
The motor is over-
loaded. 1. Remove the trimmer
head from the grass.
2. The motor will recover
to work as soon as the
load is removed.
3. When you cut, move
the trimmer head in and
out of the grass to be cut
and remove no more than
8" in pass.
The battery pack
or machine is too
hot. 1. Cool the battery pack
until its function returns
to normal.
2. Cool the machine for
approximately 10 mi-
nutes.
The battery pack is
disconnected from
the tool. Install the battery pack
again.
The battery pack is
depleted. Charge the battery pack.
7
English
EN