English (Original Instructions)
4
EN
DE ES
IT
FR PT NL RU
FI
SV NO DA PL CS SK SL HR HU RO BG EL AR TR HE LT
LV ET
CARE AND MAINTENANCE
DANGER
Prior to all servicing:
Switch machine off. Disconnect the mains plug. Wait
until the device has stopped. Ensure that there is no
more pressure on the device and all used compressed
air tools and accessories.
Leave the device and all used compressed air tools
and accessories to cool down.
After all servicing:
Put back into operation and check all safety installations.
Ensure that there are no tools or similar at or in the device.
Repair and maintenance work other than described
in this section must only be carried out by qualified
specialists.
Important information
Maintenance and test have to be planned and
carried out in accordance with the legal provisions
in line with the setup and mode of operation of the
device.
Regulatory authorities may ask to view respective
documentation.
Regular maintenance
Prior to every start
–
Check compressed air hoses for damage and replace, if
necessary.
–
Check that all screw fittings are seated securely, and
tighten if necessary.
–
Check connection cables for damage, and, if
necessary, have it replaced by a qualified electrician.
Daily
–
Drain the condensed water of the pressure vessel at
the condensate outlet (3).
Every 50 hours of operation
–
Clean air filter (10) (see fig. D)
Every 250 hours of operation
–
Clean air filter (10) or replace (see fig. D).
Every 1000 hours of operation
–
Have an inspection carried out in an authorised
service centre. This significantly increases the service
life of the compressor.
Storage of device
1. Switch off the device and pull mains plug.
2. Depressurise the pressure vessel and all connected
compressed air tools.
3. Drain the condensed water of the pressure vessel at
the condensate outlet (3).
4. Store the device in such a way that unauthorised
persons cannot start it.
CAUTION
Do not store the tool outdoors or in damp
conditions without protection.
Danger of frost
CAUTION
Frost (< 5 °C) destroys the pump and accessories as
both always contain water! If there is a danger of frost
disassemble pump and accessories and store in frost-free
conditions.
REPAIRS
DANGER
Repairs to power tools must be carried out by qualified
electricians only!
If you have Greenworks devices that require repairs, please
contact your Greenworks service centre.
ENVIRONMENTAL PROTECTION
DANGER
The condensed water from the pressure vessel contains
oil residue and /or contaminations hazardous to the
environment. Dispose of the condensed water in an
environmentally-friendly manner using respective collection
sites!
DANGER
Observe national regulations on environmentally compatible
disposal and on the recycling of disused machines,
packaging and accessories.
Recycle raw materials instead of disposing
of as waste. The machine, accessories and
packaging should be sorted for environmental-
friendly recycling.
