19
English (Original Instructions)
Remove the blade nut, spacer, blade insulator, and
properly, the blade should be flat against the blade
Replace the blade insulator and spacer, then thread
the blade nut on the shaft and finger tighten.
is 62.5~71.5 kgfcm (350-400 in.-lb.).
See figure 11.
To ensure smooth operation of wheels, the wheel
Replace the washers, pins and the wheel covers.
TROUBLESHOOTING
Problem
Possible cause
Solution
Motor refuses to start
Power turned off
Turn power on
Mains socket faulty
Use another socket
Extension cable damaged
Inspect cable, replace if damaged
Fuse faulty/blown
Replace fuse
Grass too long
Increase height of cut and tilt garden
product to reduce starting load
Motor protector has activated
Allow motor to cool and increase
height of cut
Garden product functions
intermittently
Extension cable damaged
Inspect cable, replace if damaged
Internal wiring of garden product
damaged
Contact Service Agent
Motor protector has activated
Allow motor to cool and increase
height of cut
Garden product leaves ragged finish
and/or Motor labours
Height of cut too low
Increase height of cut
Cutting blade blunt
Replace the blade
Possible clogging
Check underneath the garden
product and clear out as necessary
(always wear gardening gloves)
Blade fitted upside down
Refit blade correctly
Blade not rotating while garden
product switched on
Cutting blade obstructed
Switch off garden product Clear
obstruction (always wear gardening
gloves)
Blade nut/bolt loose
Tighten blade nut/bolt
Excessive vibrations/noise
Blade nut/bolt loose
Tighten blade nut/bolt
Cutting blade damaged
Replace the blade
If these solutions do not solve the problem contact your authorised service dealer.