•
The jack stands should not allow the machine to move
when the traction drive system is running and the drive
wheels are rotating. Use only certified jack stands. Use
only appropriate jack stands, with a minimum weight
rating of 2000 pounds (907.2 kg) to block the unit up.
Use in pairs only. Follow the instructions supplied with
the vehicle stands.
•
Do not touch hot parts of machine.
•
Keep nuts and bolts tight, especially the blade attachment
bolts. Keep equipment in good working condition.
•
Never tamper with safety devices. Check their proper
operation regularly.
•
Turn the key to the “OFF” position before unclogging the
discharge chute.
•
Never clear the discharge chute with the machine
running. Turn the key to the “OFF” position and be sure
the blades have stopped before cleaning. Use a stick to
clear a plugged discharge area. Never use your hand!
•
Stop unit and allow blades to stop before unclogging
chute. Grass collection system components are subject to
wear, damage and deterioration, which could expose
moving parts or allow objects to be thrown. Frequently
check components and replace with manufacturer’s
recommended parts, when necessary.
•
Exercise caution when working under the deck as the
mower blades are extremely sharp. Wear gloves and use
extra caution when servicing them.
•
Use only genuine Greenworks Commercial Mower parts
to ensure that original standards are maintained.
•
Always remove batteries when transporting unit. Keep
unit free of grass clippings, leaves and other debris.
14
TRANSPORTATION AND
STORAGE
14.1 TRANSPORTATION
WARNING
Use extra care when loading or unloading the machine into
a trailer. Press the low speed drive button and carefully
move the drive levers as needed to control the speed.
Always back onto the trailer when loading. When loading
or unloading the mower, do not exceed the maximum
recommended operation angle of 15°. Failure to follow
these instructions can result in loss of control and result in
death, serious personal injury, or property damage.
WARNING
Use care when loading or unloading the mower onto a
trailer. Ensure the cutting deck is raised to the highest
position so that it is not caught on the ramp. The wheels on
the mower can go off the ramp or trailer, causing the mower
to pivot or tip over, and result in a crush hazard that can
cause death or serious personal injury.
1. Park the mower on a level surface.
2. Raise the cutting deck to the highest position.
3. Position and secure ramp to the trailer according to
manufacturer’s instructions.
NOTE
We recommend you use one full width loading ramp
that is at least 1 ft. wider than the mower to minimize
the risk of the mower’s wheels going off the side of the
ramp.
4. Slowly back the mower onto the ramp and into the trailer.
5. Lower mower deck completely.
6. Set the parking brake.
7. Turn off mower and remove key.
8. Secure the mower as needed using straps or cables to
prevent movement during transport.
WARNING
To avoid accidental starting or movement that could
result in serious personal injury, always remove the start
key and set the parking brake when transporting the
mower.
15
CLEANING AND STORAGE
15.1 CLEAN THE MACHINE
High pressure
washer
Hose connector
•
Remove any build-up of grass and leaves on or around
the motor cover (do not use water).
•
Occasionally wipe the mower clean with a dry cloth.
•
If debris builds up on the underside of the mower during
use, stop the motor, turn off the machine, and scrape it
clean using an appropriate tool.
•
To clean the blade, connect a high pressure washer to the
hose connector under the blade deck. Turn on the blade
while you clean the blade.
15.2 STORE THE MACHINE
The following steps should be taken in order to prepare the
machine for storage.
•
Clean the machine as described in the previous section.
22
English
EN
P0803155-00 v1.3
