2. Move the auxiliary handle (4) above the metal ring (8)
and make sure that the metal ring (8) fits between the slot
on the auxiliary handle (4).
3. Align the holes on the auxiliary handle (4) and the metal
ring (8).
4. Put the handle knob (5) through the holes and tighten it.
7.3
ATTACH THE SHAFT
9
10
5
NOTE
If the button does not release fully in the location hole, the
shafts are not locked into position. Turn from side to side
until the button is locked into position.
1. Loosen the lock knob (5) on the coupler.
2. Align the release button (9) with the location hole (10)
and move the two shafts together.
3. Turn the upper shaft until the release button (9) locks into
the location hole (10).
4. Tighten the lock knob (5).
7.4
INSTALL THE BATTERY PACK
12
11
WARNING
•
If the battery pack or charger is damaged, replace the
battery pack or the charger.
•
Stop the machine and wait until the engine stops before
you install or remove the battery pack.
•
Read, know, and do the instructions in the battery and
charger manual.
1. Align the lift ribs on the battery pack (12) with the
grooves in the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack (12) locks into place.
3. When you hear a click, the battery pack is installed.
7.5
REMOVE THE BATTERY PACK
1. Push and hold the battery release button (12).
2. Remove the battery pack (11) from the machine.
8
OPERATION
WARNING
Wear eye protection during operation.
8.1
COLD WEATHER OPERATION
The safe battery operation temperature ranges from 1°F
(-17°C) to 113°F (45°C).
8
English
EN
