Ceiling Exhaust Fans
6
®
Fig.3
Joist
Screws
(ST4X20)
Active Part
Fig.4
2 Screws
(ST4X30)
Position
of adaptor
Fig.5
Buckle
Fan Body
3 Screws
(ST4x30)
Fig. 5
CAUTION
Hold the fan body to prevent falling before installing
the screws.
Fig.6
Circular duct
Duct tape
Fig. 7a
Fig. 7b
Fig.8
Attach cable clamp to Knockout Plate.
Knockout Plate mounts to outside of
housing and may be oriented as desired.
Connect wires with UL approved connectors.
Insert Screw from Parts Bag
Align Knockout Plate to Housing
Black
Red
Green
Wire nuts
White
Wire Nuts
inches (mm)
Caulk
Ceiling
Caulk
10-3/8 (265)
10-3/8 (265)
1
2
3
4
Black Wires
White Wires
Green Wires
Red Wires
Fig. 6
Fig.6
Circular duct
Duct tape
Fig. 7a
Fig. 7b
Fig.8
Attach cable clamp to Knockout Plate.
Knockout Plate mounts to outside of
housing and may be oriented as desired.
Connect wires with UL approved connectors.
Insert Screw from Parts Bag
Align Knockout Plate to Housing
Black
Red
Green
Wire nuts
White
Wire Nuts
inches (mm)
Caulk
Ceiling
Caulk
10-3/8 (265)
10-3/8 (265)
1
2
3
4
Black Wires
White Wires
Green Wires
Red Wires
IMPORTANT
Follow all local electrical and safety codes, as well as
the National Electrical Code (NEC) and the National
Fire Protection Agency (NFPA), where applicable.
Follow the Canadian Electric Code (CEC) in Canada.
Fig. 7a
Fig. 7b
Fig.3
Joist
Screws
(ST4X20)
Active Part
Fig.4
2 Screws
(ST4X30)
Position
of adaptor
Fig.5
Buckle
Fan Body
3 Screws
(ST4x30)
Fig. 4
4. Place the adaptor on the bracket assembly as
indicated and install it by using 2 self-tapping screws
(ST4X30). See Fig. 4
5. Push the fan body upwards until the fan body
engages the buckle on the adaptor and secure the
fan body by using the other 3 self-tapping screws
(ST4X30). See Fig. 5
6. Install circular duct and secure it with clamps or ties
and seal it with mastic or approved duct tape. Duct
adaptor can accept 4, 5 or 6 inch (101.6, 127 or
152.4 mm) circular duct. See Fig. 6
7. Remove the knockout plate and secure conduit or
stress relief to knockout hole. See Fig. 7a.
Refer to wiring diagrams on page 3. Use UL
approved connectors to connect the incoming power
wires to the ventilation fan wires, see Fig. 7b. Then
attach knockout plate to the fan body.
