Page
15
of
28
Version 4.37 • CE • ALIS Tube Lamp
21 May 2019
3.4 Hub supply cable termination (CE)
Connect the P2M Connector to a 3-core adequately rated mains supply cable by inserting into the screw terminals
as shown below. Ensure there are no frayed copper strands and the supply is adequately protected to meet all
local wiring regulations. Not applicable if installing a Greengage Power Hub Panel.
Note: For assembly instructions of P2M connector see appendix: Assembly instruction – P2M
connector supply.
3.5 Hub supply cable termination (UL)
Connect the IEC C13 Connector to a 3-core adequately rated mains supply cable by inserting into the screw
terminals as shown below. Ensure there are no frayed copper strands and the supply is adequately protected to
meet all local wiring regulations.
3.6 System connection
a.
Connect the ALIS Bus to the ALIS Dimmer as shown in the ALIS system components diagram (page 5).
b.
Connect the ALIS Dimmer to the ALIS Power Hub as shown in the ALIS system components diagram
(page 5).
c.
Connect the selected dimming control method to the ALIS Dimmer. Dimming is possible via either an ALIS
Dimmer Pot or a 0-10VDC control signal, ensuring polarity is maintained, as shown in the ALIS system
components diagram (page 5).
Connecting ALIS Dimmer to ALIS Pot/0-10VDC (Not applicable if installing the Greengage Power Hub Panel).
Connectors of the same shape can be connected.
Multiple ALIS Dimmers can be controlled with a single ALIS Pot, Greengage DTD
Controller or another 0-10VDC supply.
The potentiometer connection to the hub can also be used to extinguish the lamps via the
use of a timer switch or on/off switch, which avoids the necessity of disconnecting the
mains supply.
Please contact
for additional information as required.
Blue
Yellow/Green
Brown
