Instructions
STEP 1. TESTING THE
TRANSMITTER AND
RECEIVER WITH BATTERIES
STEP 2. INSTALLING THE
TRANSMITTER TO THE DOOR
Skip to STEP 5. unless you wish
to change the factory set tune
and volume or house codes.
WIREFREE BELL PUSH
STEP 3. TUNE SELECTION
& VOLUME CONTROL
Diagram 2.
STEP 5. TESTING
Diagram 1.
Transmitter
STEP 4. CHANGING THE
HOUSE CODE
The range of the unit is up to 100
metres but mounting the
transmitter on metal or UPVC
doorframes may make the unit
inoperative or seriously reduce the
operating range.
As with all low powered transmitters
the number of wall and ceilings the
signal has to travel though between
the transmitter and receiver also
affects the range.
Once a suitable surface is found
remove the transmitter base
following 1).
Use these as templates to fix the
base on to a doorframe. Ensure the
transmitter is the right way up so
that the slot is at the bottom.
If mounting on to masonry, wall
fixings will be required. Refit unit to
base.
IMPORTANT: The screws must be
fixed flush or the battery will not
maintain contact with the terminals
and the unit will not operate.
The unit comes with a factory
pre-set tune but it can be changed.
The tune is determined by the slider
switch as in Diagram 2.
Remove transmitter in 1) above
leaving the battery in
and select
tune as shown in Diagram 2
.
Press the push button to hear the
sound each different setting
produces.
Once a desired tune is selected,
carefully replace transmitter. Up to
3 different sound options are
available.
The unit comes with factory set
code. Only change it if you
experience interference from a
neighbour’s unit.
Remove cover transmitter from base
as in 1) leaving the batteries in
position. Set dial as in Diagram 2.
to required number i.e “6”, set this
number “6” on the corresponding
dial on the receiver.
Please note if
the sequence is not identical in both
the transmitter and receiver then
the unit will not operate
. Press the
button on the transmitter to check
that the chime works and carefully
replace covers as above.
Test your doorchime by moving the
receiver in different rooms at
varying distances from the
transmitter to ascertain the
coverage available in your home,
this way you are unlikely to miss
any visitors.
MODEL NUMBER:
DW060A: Wirefree Transmitter only
• No more wires
• Battery included for Transmitter
(2 x AAA)
• Transmitter fixing screws included
Please read the instructions fully
before attempting installation.
--
1) Transmitter
The battery compartment slot is
located on the bottom of the unit.
Using a flat screwdriver insert into
slot and gently push to remove the
lower cover.
Insert the two AAA batteries
supplied and refit the base cover.
Before drilling any holes
position
the transmitter on the door or door
frame outside (ideally a flat wooden
area) and press the button to ensure
the signals are getting through to
the receiver. Please test with the
door closed to simulate actual
working conditions.
You should also look to position the
transmitter in an unexposed place to
protect from rain.
