SECTION A: GENERAL INFORMATION
Page 7
CAUTION
Green Technik undertakes no responsibility in case any safety guards or loading
hoppers installed on the machine are changed or removed, as well as in case of
non’compliance with the obligations and/or prohibitions specified in this paragraph
and, in general, of any of the rules and provisions set forth in this Handbook.
BC 260 User’s Handbook
MAX SHREDDING
DIAMETER mm. 40
MAX CHIPPING
DIAMETER mm. 90
PROHIBITED CONDITIONS OF USE
Working materials other than specified in this Handbook could arise serious
damages to your machine and risks of injury to the operator. Besides this, it is strictly
prohibited to put into machine materials like: ballast and rock pieces, section irons,
glass, plastic materials, parts of wooden boxes with nails or iron wires left therein,
trunks and/or branches having diameter higher than shown on the transfer attached
close to the month of loading hoppers.
This machine has been designed and manufactured to be utilized on flat
surfaces, compact and level as much as possible; therefore, avoid to work on steep
slopes, friable or damp grounds or however under any condition which could cause
the machine to tilt during the operation or susceptible to be prejudicial to its stability.
Whenever the machine has to be moved, the engine must be compulsorily switched
off or, in case the machine is power supplied, the main cable must be plugged out,
afterwards wait until all the machine moving parts stand still.
The same is when the machine has to be tilted or lifted for cleaning or adjusting
purposes or to release any rotating element which got jammed on the machine.
Furthermore, it is strictly prohibited to open the door placed near the discharge outlet
of the shredder, to visually check for no material inside, until the machine is quite still.
To prevent the operator from getting in touch with any moving element of the
machine, some fixed or movable safety guards have been installed, and the upper
and side loading hoppers are such in length as to avoid hands approaching to the
rotating parts.
