❏
4. Glue the two parts shown onto one of the plywood
carrying handle parts.
❏
5. Place the “N” struts onto the handle, leaving space
between the struts in the center of the handle as shown. The
remaining parts you glued together should be fit between the
“N” struts. Once you are sure the struts and the remaining
pieces fit properly, glue the plywood parts to the handle.
❏
6. Glue the 1/4" x 3/8" x 7" [6.4 x 9.5 x 178mm] balsa
stick to the handle, between the struts.
❏
7. On the remaining handle part, install a 4-40 blind nut
into each of the corner holes.
❏
8. Place the two “N” struts into the handle. Put the handle
top onto the part of the handle holding the struts and place
the completed handle on top of the cabanes. Secure the
handle to the cabanes with four 4-40 x 3/4" [19mm] socket
head cap screws and #4 flat washers. This is how the
completed handle looks when you are storing the parts or
taking the plane to the field.
❏
9. For the following building steps it will be better to
remove everything from the handle. Do this now and secure
the empty handle to the cabanes.
16
