YP2425A
Operating Instructions
Great Plains
| 401-626M | 2019-06-11
31
Folding, Continued …
If caster locks are engaged (wire handle
and
indicator
in FIELD position), they must be released
before folding.
5. At each wing caster, move the lock control handle
to the ROAD position.
6. If the indicator end of the lock
does not
immediately snap up from FIELD to ROAD, some
pivot tension is holding the pawl end of the lock
in
the plate detent
. Raise and lower planter fully to
release load on lock plates to allow them to come
open. Move the planter forward or back a short
distance until both locks unlock.
7. Set CFM Marker/Fold switch
to Fold. LED above
switch blinks continuously.
8. Activate (normally Extend) tractor Marker/Fold
hydraulic circuit to fold wings. Sequence begins with
releasing of tongue latch (Refer to Figure 22 on
page 27). Before folding completes …
9. Raise planter tongue (“
on page 20). This must be done before folding
completes.
If tongue is not raised prior to folding complete, wing
locks will be above transport hooks and unable to
secure wings to tongue.
If this happens, partially unfold planter, raise tongue,
and refold.
10. When fully folded, lower tongue so that wing locks
engage transport hooks
.
11. Set CFM Marker/Fold switch
to Marker.
Set switch to Marker even if markers are not installed.
This switch position sets the fold and caster swing
arm cylinder solenoid valves off, providing additional
protection against unfolding.
12. Set Marker/Fold circuit lever to Neutral.
13. 3-point: lower hitch completely
Hydraulic tongue: Set hitch circuit to Float (not
Neutral).
Transport Hazard:
Wing locks must be engaged for safe transport, and planter
tongue must be lowered to keep wings locked.
Hydraulic tongue, if installed, must be in Float.
Caster locks must be disengaged for transport.
Figure 31
Caster Unlocked
29306
4
5
7
6
Figure 32
CFM: Wing Folding
26033
3
8
9
Figure 33
Wings Locked
26037
8
9
9
8
Содержание Yield-Pro Air-Pro YP2425A
Страница 172: ...Table of Contents Index Table of Contents Index...
Страница 178: ...Great Plains 401 626M 2019 06 11 Table of Contents Index 174 YP2425A Table of Contents Index...
Страница 179: ...Table of Contents Index Table of Contents Index...
Страница 180: ...Great Plains Mfg 1525 E North St P O Box 5060 Salina KS 67402 Table of Contents Index...