GREAT PLAINS Yield-Pro 3PYPA, Руководство оператора

Страница: 44 / 196

Great Plains | 401-647M | 2019-06-11 Table of Contents Index 40
3PYPA Table of Contents Index Operating Instructions
Prepare Hopper (if used)
 The hopper includes a level sensor which is not
factory-installed. If you desire to use the sensor,
install it prior to first use of the hopper. See page 167.
Refer to Figure 44
1. Open hopper lid and inspect hopper:
•
Rubber latch must be intact.
If hopper is not closed securely during operations, air
leaks cause irregular seed delivery.
•
Make sure seed strainer basket is present and
clean.
•
Check that hopper is clear of residual seed and
foreign matter. See page 102 if any clean-out is
required.
•
Check lid for holes, cracks and excessive warping.
Close lid. It must seat flat when latched.
Refer to Figure 45
2. Briefly open slide gate to drain off any condensed
moisture.
Prepare Bulk Seed Box
Due to the difficulty of mixing seed lubricant down to the
base of the bulk box, Great Plains suggests:
•
Mix lubricant into the seed prior to transport of the
bulk box to the field.
•
Pour 2 cups (0.6 liter) of lubricant into the air box
before mounting the bulk box.
1. Determine the amount of seed lubricant required.
See page 133 for recommendations.
2. Open the lid of the bulk box.
3. Mix in all but 2 cups of the lubricant, stirring as
deeply as possible without damaging seed.
4. Close the lid.
Figure 44
Hopper Lid Open
29879
5
6
7
5
6
7
Figure 45
Hopper Slide Gate Open
29881