GREAT PLAINS Yield-Pro 3PYPA, Руководство оператора

Страница: 41 / 196

3PYPA Table of Contents Index Operating Instructions
Great Plains | 401-647M | 2019-06-11 Table of Contents Index 37
Wing Unfold Steps
1. Move planter to an area of level ground.
Put tractor in Park.
2. Unless rechecked recently, level the planter per
“ Frame Height and Leveling ” on page 22.
Refer to Figure 34
3. Make sure wing flex lock pins are in place.
4. Verify that the wing lock pins are available, and
are not in the wing lock-down holes. Normally, in
storage, transport and set-up, these pins are stored
in dedicated holes in the parking stand bracket.
Machine Dam age Risk:
The INNER pins must be IN
and the
OUTER pins
must be OUT
during folding and unfolding,
or machine damage will result.
Refer to Figure 33
5. Set all CFM FRAME switches off (down).
6. Raise planter.
Refer to Figure 35
7. Set CFM FRAME switch “ Wing Fold ” to on (up).
8. Activate (normally Extend) tractor hydraulic circuit to
unfold wings.
9. When fully unfolded, set hydraulic circuit to off.
Refer to Figure 36
10. Set “ Wing Fold ” switch to off (or marker operations
are disabled).
Refer to Figure 37
11. Insert wing lock pins .
Refer to Figure 34
If operation will be over uneven ground, remove wing flex
lock pins , and store in parking stand bracket holes .
Marker Fold Marker Tilt
FRAME
Wing Fold Right
CLUTCH
Center Left MASTER
Figure 33
CFM Before Wing Unfold
29869
1
Figure 34
Flex Lock & Pin Storage
25247
2
3
2
3
1
2
Marker Fold Marker Tilt
FRAME
Wing Fold Right
CLUTCH
Center Left
MASTER
Figure 35
CFM During Wing Unfold
Marker Fold Marker Tilt
FRAME
Wing Fold Right
CLUTCH
Center Left
MASTER
Figure 36
CFM After Wing Unfold
29869 2
Figure 37
Wing Lock Pin Locations
25248
1
2
1 3