GREAT PLAINS PL5700, Руководство оператора

Страница: 29 / 150

PL5700 Planter Table of Contents Index Operation
Great Plains | 411-681M | 04/08/2021 22
With IntelliAg ISO6
1. If installed, remove cylinder locks and stow in
storage position.
2. Use tractor lift hydraulic lever to lower the planter.
3. Set tractor lift hydraulic circuit to “Neutral”.
With Switch Box
1. If installed, remove cylinder locks and stow in
storage position.
2. On the switch box, toggle the on/off power switch
to
ON.
3. On the switch box, toggle the marker/fold switch
to
MARKER.
4. On the switch box, toggle the lift switch to the
center position WHEELS.
5. Use tractor lift circuit lever to lower the planter.
6. Set the lift tractor circuit level to “Neutral”.

Field Position
You will achieve field position by lowering the planter
into the field and pulling forward a few feet.

Unfolding
Pinch Point and Crushing Hazards
Moving parts can pinch or crush causing
serious injury or death. Distance between
tractor and planter will decrease when
unfolding and increase when folding. Keep all
persons away when folding or unfolding the
planter.
Flailing Hazard
Marker hydraulics are active whenever the fold
hydraulics are not in use. It is important to set
the tractor fold/marker hydraulic circuit lever to
“Float” or “Neutral” to prevent unintended
marker operations. Unexpected marker operation
and flailing equipment can serious injures
including death.
Tire Damage Risk
Verify the tractor gear is in “Neutral” before
folding or unfolding to avoid damage to tires.
Planter Damage Risk
Do not fold or unfold without first fully raising
planter completely or damage will occur.
The distance between the tractor and planter frame
will decrease by about 10 ft (3 m) during unfolding.
The planter and/or tractor will move during this
operation.
The two-point hitch is raised and lower during the
operation to adjust the tongue height.
If the planter is equipped with a rear auxiliary hydraulic
drive system, set the selector valve (1), near the
sequence valve (2), near the wing hinge on the left
wing to “Marker”. This selection must be made even
when the planter is not configured with optional
markers or the fold hydraulics will not be able to be
activated.
With IntelliAg ISO6
1. Move the planter to level ground with adequate
overhead and side-to-side clearances for the
unfold operation.
TP-71665
TP-71665
TP-71665
!
!
!
!
28496
1
2