GREAT PLAINS NTA3007HD, Руководство оператора

Страница: 73 / 178

NTA907HD and NTA3007HD Table of Contents Index Operating Instructions
Great Plains | 166-207M | 02/26/2019 Table of Contents Index 67
20. If the drill will not be used again for an extended
period, complete the steps at “ Problem Clean-Outs ”
on page 108.
21. Wipe down doors and bottom of meter.
22. Close doors. For temporary parking or transport, fully
close doors. For storage, close doors only until
elastomer seals begin to touch meter housing, so
that condensation can drain. Do not leave doors
open enough for pest entry.
Auger Unloading: Front Hopper
The on-board auger is not designed for routine use as an
unloading aid at the front hopper. With the polymer inlet
hopper installed, the inlet end of the auger does not fit
under the front meter. Additionally, the outlet end of the
auger may be too low for your collection bin or vehicle.
Great Plains recommends:
•
planning operations to exhaust materials in the front
hopper (or use only the rear hopper for single-hopper
tasks), or;
•
use the non-auger unloading procedure (page 64)
for the front hopper.
Removing the polymer inlet hopper from the auger allows
the auger to be swung under the front hopper meter.
However, without the inlet hopper, the auger inlet will not
catch all the falling material.
The loose inlet hopper can be placed under the auger
inlet to catch the excess, and divert some of it to the inlet.
Unload the rear hopper first. Then use the same steps as
for unloading the rear hopper, with these changes:
7a. Before step 7(b) on page 65, remove the auger inlet
hopper.
7c. After step 7(b), maneuver inlet hopper under inlet.
Auger Unload: Hydraulic Circuit Operation
Lift
Fan,
Auger
Fold, Tilt,
Marker
Transport
Hooks
Neutral
Float or
Neutral
Neutral Neutral