GREAT PLAINS 1510HDP, Руководство оператора

Страница: 42 / 135

Great Plains | 118-949M | 2018-07-03 Table of Contents Index 38
1525P and 1510HDP Table of Contents Index Hydraulic Drive Operation
Prime Seed Meters
Before running an actual calibration, enter the amount of
seed you want to measure. For Volumetric metering, this
should be at least
1

4
pound. For singulated metering, at
least 100 seeds should be selected. Step 19 through
step 30 executes a short calibration to do this.
Refer to Figure 29
19. Enter a small target amount.
Refer to Figure 30
20. It may take some experimenting to select a value
that avoids “TIME TOO LOW” errors.
Press FUNCTION button to return to step 19.

If modest adjustments to the sample size continue to
result in HIGH/LOW errors, chances are some other
parameter is zero or incorrect by a large factor (such
as decimal place error). To start over, press OFF, and
then ON.
Refer to Figure 31
21. The minimum time is 4 seconds. Select a time just
long enough to ensure that the meters are filled with
seed, and seed is flowing to all seed tubes to be
sampled.
Figure 29: Priming:
Set for Short Run Time
28308
Figure 30: Priming:
Time Limit Error
28257
Figure 31: Priming:
Short Cal. Mode Time
28309