56
M_LS100IQ EX Energy_EN_C
N. Adaptable accessories
List of accessories available upon request
1. Cylinder attachment
Used to mark cylindrical parts thanks to a rotary marking device. This accessory is designed to hold glasses,
mugs, cups, etc.
This accessory is placed on the engraving table.
Installation - Use: Refer to the manual.
2.
Cutting out kit
Used to support the material to be cut at a distance from the surface of the engraving table to minimize the area
of contact with the surface. The cutting out kit comprises 4 removable plate(s), pins (supports) and end stops.
The plate to be cut out rests on the pins positioned in advance on 2, 3 or 4 of the removable plates which are
arranged on the engraving table according to the dimensions of the part. In all cases place 5 pins (supports)
at the location of ZRef (top left corner).
The cutting table redirects the exhaust air over and under the material to clear the engraving area of fumes.
